Wood Turning the Ball and Icicle Christmas Ornament
Intermediate/Advanced Woodturning Project (4)
| Using a 1/4" round skew or other tool of your choice, finish the last drip and turn a decorative top to the icicle. Blend the icicle into the icicle base and taper the base toward the icicle. Sand and finish. |
|
| I like a 1/4" skewchigouge for cove cuts like this but a detail gouge will do a nice job as well. Sand and finish. |
|
| Make a "V" cut behind the base for a taper. Later this will give a better transition from the ball. |
|
| Behind the "V" use a parting tool to make a 3/4" or 5/8" tenon. Undercut the base slightly, sand and finish. |
|
| Part off the icicle leaving about a 1/8" long tenon. |
|
| Establish a tenon 3/8" diameter and 1/8" long in the top section. |
|
© 2006 copyright Darrell Feltmate, Around the Woods, Wood Turning Techniques